Craftsman T110 Owner's Manual

The Craftsman T110 is a 42-inch riding lawn mower featuring a 19.5 HP Briggs & Stratton engine, 6-speed manual transmission, 3-in-1 cutting system (mulch, bag, side discharge), electric start, adjustable cutting height (1.5-4 inches), comfortable high-back seat, and durable steel frame. Below are key sections for safety, features, assembly, operation, maintenance, and troubleshooting.

Features at a Glance

Key components: 19.5 HP engine, 6-speed transmission, cutting deck, steering wheel, seat, battery, fuel tank, and blade engagement lever.

Assembly Instructions

Unpack and inspect all parts. Assembly requires basic tools.

1. Install steering wheel: Align and tighten bolt with provided wrench.
2. Attach seat: Mount seat bracket to frame using bolts and washers.
3. Connect battery: Attach red (+) then black (-) cables to battery terminals.
4. Install cutting deck: Lower deck onto mounting points and secure with pins.
5. Add fuel: Use fresh unleaded gasoline (87 octane minimum).

WARNING! Mower is heavy; use assistance during assembly. Ensure all bolts are tightened securely.

First-Time Operation

Perform pre-operation checks before starting engine.

1. Check oil level: Ensure oil is at full mark on dipstick.
2. Inspect fuel: Fill tank with fresh unleaded gasoline.
3. Adjust seat: Position for comfortable reach to all controls.
4. Set cutting height: Use deck lift lever to desired height.
5. Start engine: Insert key, set parking brake, press brake pedal, turn key to START.

CAUTION! Always operate on level ground. Keep hands and feet away from moving parts.

Specifications

• Engine: 19.5 HP Briggs & Stratton, single-cylinder, OHV.
• Transmission: 6-speed manual, shift-on-the-go.
• Cutting Deck: 42-inch, 3-blade, reinforced steel.
• Cutting Height: 1.5 to 4 inches (6 positions).
• Fuel Type: Unleaded gasoline (87 octane minimum).
• Fuel Capacity: 2.5 gallons.
• Battery: 12V, 230 CCA.
• Turning Radius: 18 inches.
• Weight: 450 lbs (approximate).
• Warranty: 2-year limited warranty.

Controls and Settings

Operator station includes steering wheel, ignition key, gear shift, brake pedal, and deck controls.

Dashboard: Ignition switch, hour meter, headlight switch (if equipped).

Transmission: 6-speed shift lever (1=slowest, 6=fastest). Cutting Height: Deck lift lever with 6 positions. Blade Engagement: Electric PTO lever (pull to engage blades). Parking Brake: Set lever located near seat. Throttle/Choke: Control lever on dashboard.

Attaching Accessories

Compatible with bagger, mulching kit, and tow-behind cart.

1. Turn off engine and remove key before attaching accessories.
2. Bagging system: Install chute adapter to deck discharge opening.
3. Mulching kit: Replace standard blades with mulching blades and install plug.
4. Tow hitch: Attach to rear frame using provided hardware.

Tip: Refer to accessory manual for specific installation instructions.

Mowing Operations

Supports multiple mowing modes: mulching, bagging, side discharge.

1. Start mower: Engage parking brake, press brake, turn key.
2. Select speed: Begin in 1st gear, shift up as needed.
3. Engage blades: Pull PTO lever while moving at slow speed.
4. Adjust pattern: Overlap passes by 2-3 inches for even cut.
5. Slope mowing: Mow up and down slopes, never across.
6. Finish mowing: Disengage blades, return to slow speed, park on level surface.
7. Clean deck: After use, raise deck and remove grass clippings.

WARNING! Never mow wet grass. Always look behind before backing up.

Safety Features

Seat Safety Switch: Engine stops if operator leaves seat with blades engaged. Blade Brake Clutch: Stops blades within 3 seconds when disengaged. Parking Brake: Prevents rolling when parked.

Care & Maintenance

Regular maintenance ensures optimal performance and longevity.

1. Check oil every 8 hours; change every 50 hours or seasonally.
2. Replace air filter every 25 hours or when dirty.
3. Sharpen blades every 25 hours for clean cut.
4. Check tire pressure monthly; maintain 12-14 PSI.
5. Clean underside of deck after each use.
6. Store in dry, covered area; use fuel stabilizer if storing over 30 days.

CAUTION! Disconnect spark plug wire before performing any maintenance.

Regulatory Information

EPA Certified: Meets emission standards for small nonroad engines. Copyright © 2023 Craftsman; trademarks of Stanley Black & Decker, Inc. Safety Compliance: Meets ANSI/OPEI B71.1-2017 safety standards. For support, visit www.craftsman.com or contact 1-888-331-4569.

Troubleshooting

Reset: Turn key to OFF position for 30 seconds to reset safety switches.

Service: 1-888-331-4569; www.craftsman.com